POWER
B
POWER
_'_ STOP
(_WER _
Press [PROG/CHECK].
The timer recording list appears,
Icon explanations
i
The times ovedap those in another program.
• This program is currently recording.
O The disc was full or the maximum number of programs or scenes
was reached so the program failed to record.
The material was copy-guarded so the matedal failed to record.
0 The program failed to record for some other reason.
• To change the program
" page 47
• To exit the timer recording list
Press [PROG/CHECKJ or [RETURN]. (The television is shown.)
For your reference
Programs that failed to record are displayed gray. These Jim
programs are deleted from the list at 4 a.m. the day after
Ullm
tomorrow.
• To release the unit from recording standby []
]f you want to record something else before the program start time,
for example:
Press [_), POWER].
The unit turns on and =Fq"goes out.
eSe sure to press [_), POWER] before the program start time to put
the unit on timer recording standby. The program only works if =rq"
is on.
• To put the unit on timer recording standby []
Press [_, POWER].
The unit turns oft and "_" lights on the unit*s display.
"[_" flashes when the unit couldn't go to timer recording standby
(e.g., a disc isn't loaded, a disc that can't be recorded to is loaded,
or the disc is protected). Check the disc carefully.
• To stop recording while a program is working []
Press [_, POWER], then [11, STOP] within
5 seconds.
Recording stops. Recording standby is also canceled if there are
other timer recording programs, so be sure to press [(_, POWER] to
put the unit on timer recording standby.
a
To Next Page
Loading...
