Panasonic DMR-EZ49VEB

19
U80 ST Microprocessor
Communication Error on
Timer Bus
Display appears when ST Microprocessor
Communication Error on Timer Bus occurs.
No display
U80 is displayed till [POWER] key is
pressed.
U81 ST Microprocessor
Communication Error on
UART
Display appears when ST Microprocessor
Communication Error on DART occurs.
No display
U81 is displayed till [POWER] key is
pressed.
U88 The unit is carrying out its
recovery process.
No display
U99 Hang-up Displayed when communication error has
occurred between Main microprocessor
and Timer microprocessor.
No display
Displayed is left until the [POWER]
key is pressed.
H19 02 Inoperative fan motor When inoperative fan motor is detected
after powered on, the power is turned off
automatically.
The event is saved in memory.
No display No display
F00 No error information Initial setting for error code in memory
(Error code Initialization is possible with
error code initialization and main unit initial-
ization.)
No display No display
F34 Initialization error when main
microprocessor is started up
for program recording
When initialization error is detected after
starting up main microprocessor for pro-
gram recording, the power is turned off
automatically.
The event is saved in memory.
No display No display
F58 Drive hardware error When drive unit error is detected, the event
is saved in memory.
No display No display
F60 DVD module has not been
started.
Defect of Digital P.C.B., defect of regulator
circuit for Digital P.C.B. and so on.
Mode: No change
No display
F74 HDMI Device Key Communi-
cation error
HDMI connection could not be authenti-
cated due to a transfer malfunction.
Factor of HDMI Device key-road failure
• When HDMI LSI is damaged.
• When the bus line of I2C doesn't oper-
ate normally.
• When device key information recorded
is damaged.
No display
F75 HDMI Device Key Information
error
HDMI connection could not be authenti-
cated due to an internal data malfunction.
Factor of HDMI Device key-road failure
• When HDMI LSI is damaged.
• When the bus line of I2C doesn't oper-
ate normally.
• When device key information recorded
is damaged.
No display
UNSUP-
PORT
Unsupported disc error *An unsupported format disc was played,
although the drive starts normally.
*The data format is not supported, although
the media type is supported.
*Exceptionally in case of the disc is dirty.
“This disc is
incompatible.”
Display for 5 seconds.
The character indication flows side-
ways.
Error Code Diagnosis contents Description Monitor Display Automatic FL display