Panasonic DP-190 - Page 70

70
UF-9000
JUN 2004
Ver. 2.0
DP-180/190
4.1.6. F7 Mode: Electronic Counter
Set the machine to Service Mode and press "7" key on the Keypad.
↓
Press the "START" key.
↓
Enter the desired code number or press “V”, ”/\” arrow keys.
↓
Press the "SET" key.
↓
Enter the desired function code number and press “SET” key.
↓
When the “CLEAR” key is pressed, the selected code input will not be accepted.
↓
Press “STOP” key, then press “FUNCTION” and “CLEAR” keys simultaneously to exit the service mode.
↓
Reboot the machine after setting the parameter(s) to activate the setting(s).
91 Original Lead ADF Adjustment of original detection timing. -99 - +99
0.3mm
92 Original Trail ADF Adjustment of trail edge detection timing. -90 - +127
0.3mm
93-98 Not Used
99 F5/F6 Initialization Initialize F5/F6 parameter settings.
F7 Mode
No. Item Remarks
01 Key Operator ID Code Key Operator’s identification code for access to the
counter mode.
02 Total Count Total count for all copies / prints.
03 PM Count Preventive Maintenance count.
04 Scanner PM Count PM count for scanner readings.
05 Not Used
06 OPC Drum Count PM count of recording paper fed through the OPC
Drum.
07 Process Unit Count PM count of recording paper fed through the
Process Unit.
08 ADF PM Count PM count of originals fed through the ADF.
09-10 Not Used
11 Sheet Bypass Count Total count of paper fed from the sheet bypass.
12 1st Paper Tray Count Total count of paper fed from the 1st paper tray.
13 2nd Paper Tray Count Total count of paper fed from the 2nd paper tray.
14-15 Not Used
16 2-sided Count Total count of 2-sided Print.
17 ADF Count Total count of originals fed through the ADF.
18 ADF Read Count Total count of originals scanned through the ADF.
F6 Mode
No. Item Remarks
Setting
Range