21
Getting To Know
Your Machine
When the optional Paper Tray-2 is installed, and either Paper
Tray (Tray-1 or Tray-2) is not closed firmly, paper jam may
occur.
(Side View)
Correct
Incorrect
NOTE: When the optional Tray-2 is installed and the same size of paper is loaded in both trays, the paper will feed from
Paper Tray-2 first. This is the default setting, if you wish to change the setting, please consult with your service
provider.
(Adding Paper / Sheet Bypass)
If you wish to make multiple copies from the Sheet Bypass (Thick media), input the desired number of copies first, then
insert the first sheet of media into the Sheet Bypass and press the Start key. After each media sheet is processed, a
“BYPASS ADD PAPER” prompt message will appear on LCD display, feed an additional media into the Sheet Bypass
(one-at-the-time) until your copy job is completed.
(Adding Paper / Tray-2)
Always remove all paper from Tray-2, fan the paper and straighten the stack when replenishing paper. This helps prevent
multiple sheets of paper from feeding through the Tray-2 at one time, thus reducing paper jams.
ATTENTION
To Next Page
Loading...
