51
KX-MB2230EU/ KX-MB2270EU/ KX-MB2515EU/ KX-MB2545EU/ KX-MB2575EU/ DP-MB310EU
<Stop operation>
In order to stop the motor rotation, following 2 signals are supplied from IC300.
1. SS signal (Output pin: Pin D24/Output Signal: "L")
When this signal is inverted by transistor Q502 and becomes "H", motor recognize this signal as "stop" signal.
2. Brake signal (Output pin: Pin D26/Output Signal: "L")
When this signal is inverted by transistor Q526 and becomes "H", motor recognize this signal as "brake on" signal.
Timing Chart of Stop operation
6.7.1.1. Main Motor Drive Circuit
To Next Page
Loading...
