m
i Adding an amplifier and speakers to your system- Connectionand settings
Use the following chart when you wish to add an amplifierand speakers to yoursystem. Further informationis qivenon the following pages.
Connectlon*l Digital output eetUng Speaker setting
(=F Page 38) (,,k Page 40)
You want to enjoy the 5.1-channel • An amplifierwith5.1-channel • Set PCM Down • Set all speakers to on
surround sound recorded on DVDs inputterminals Conversion to "No" (Large. Small orYes).
using the unit's built-in decoder. •A 5.1-channel speaker • Correct output balance
system • Set delay time
(,_ Page 35)
You want to enjoy the 5.1-channel =A decoder • Set PCM Down • No settingsrequired
surround sound recorded on DVDs =An amplifier with5.1 -channel Conversion to "Yes" • Make speaker settings on
using the decoder in another unit inputterminals • Set Oolby Digital and DTS the decoder.
(e.g., a dlgital sound processor), eA 51-channel speaker Digital Surround to
system "Bitstream"*2
(..I. Page 36)
You want to connect a 2-channel =A 2-channel analog amplifier • Set PCM Down • No settings required
analog amplifier (including Dolby Pro (mS.Page 37) Conversion to "No" • Some settings are required
Logic amplifiers), on Dolby Pro Logic amplifiers
You want to connect a 2-channel • A 2-channel digital amplifier • Set PCM Down • No settings required
digital amplifier. (=_ Page 37) Conversion to "Yes"
=Set Dolby Digita! and DTS
Digital Surround to "PCM"
You want to record onto a cassette • A cassette deck =Set PCM Down • No settings required
deck or other analog recording • An amplifier Conversion to "No"
device. P (=) Page 37)
You want to record onto an MD deck • An MD deck =Set PCM Down • No settings required
or other digital recording device.*3 ('_ Page 37) Conversion to "Yes"
=Set Dolby Digdal and DTS
Digital Surround to "PCM"
You want to connect 3 speakers. • An amplifier with5.1-channel • Set PCM Down • Set center to on (Large or
inputterminals Conversion to "No" Small).
• Your speakers, two front and • Set surround to "No".
one center. =Correct output balance
(_ Page 35) • Set delay time
You want to connect 4 speakers. • An amplifier with 5.1-channel • Set PCM Down • Set surround to on (Large or
input terminals Conversion to "No" Small).
• Your speakers, two front and • Set center to "No",
two surround. • Correct output balance
(_" Page 35) • Set delay time
• 1 Equipment listed are examples.
• 2 If your decoder is not able to handle DTS signals, set Colby Digital to "Bitstream" and DTS Digital Surround to "PCM".
• 3 Connect digital equipment that is able to handle a 48 kHz/16 bit sampling rate. You cannot record digitally if there is a copy guard on the disc.
Turn V.S.S. (=_ page 16) off when you connect more than just the two front speakers.
Sound wtll not be output from the o her speakers if V.S.S.
iS on,
vQ'rgg54
To Next Page
Loading...
