Panasonic DVD-A7

II
f
I
Operating your televisionor amplifier
VOL
[+]H
\
STOP FAUSIE pLAy
r-n C2) 1_ r--n
F-1 c-l_
1223 r_l
d _
I_.FTt_J
- AMP VOL +] f
You can use the remote control to operate your television and to
control the volume of amplifiers manufactured by Technics.
First enter the code for your television.
Press and hold the [POWER] button for this unit
and enter the two-digit code.
Refer to this chart for the code for your television,
Code Manufacturer Code Manufacturer
0O " GE (OLD) 08 TOSHIBA 2
01 RCA 09 SAMSUNG
02 ZENITH 10 JVC
03 SONY 11 PANASONIC 1
04 MAGNAVOX 12 MITSUBISHI
05 TOSHIBA I/SANYO 13 SHARP
06 CURTIS MATHES 14 HITACHI
07 SEARS 15 PANASONIC 2
• If there is more than one code for the manufacturer of your
television, try each code until you find the correct one.
• You must repeat this procedure after you change the remote
control's batteries.
To turn the television on and off
Press [POWER] (TV).
TO change channels
Press [A] or [V}.
To control the volume
Press [-] to decrease the volume or[+] to increase the volume.
Press [AMP VOL (- or +)].
-: decreasesvolume
+:increasesvolume
There are some televisions and amplifiers that cannot be operated
with this remote control.
VQT83_