2 Use [3, 4] to select the play list.
≥If you press [ENTER] or select a play
list with the numbered buttons, all the
scenes in the play list are played from
the beginning.
3 Use [1] to select “Contents” on
the right side of the list and
press [ENTER].
4 Use [3, 4] to select “Scene
List” and press [ENTER].
5 Use [3, 4, 2, 1] to select the
scene and press [ENTER].
The scene starts playing.
≥You cannot move the highlighting to
places where a scene is not
displayed.
≥If there are more than 9 scenes in the
play list, use [3, 4, 2, 1] to select
“Next” and press [ENTER]. Select
“Prev” to move back.
≥You can also select a page of play list
scenes by entering the page number
with the numbered buttons. (The page
numbers appear at the top right of the
screen.)
≥∫ To enter a number
≥e.g. 25: [2]>[5]>[ENTER].
≥e.g. 111: [1]>[1]>[1]>[ENTER].
To display information about a selected
play list
1. Select the play list (steps 1 and 2).
2. Use [1] to select “Contents” on the right
side of the list and press [ENTER].
3. Use [3, 4] to select “Program contents”
and press [ENTER].
When play finishes
≥After playing a play list: the play list
selection screen appears.
≥After playing a scene: the scene selection
screen appears.
To return to the previous screen
Press [RETURN].
To clear the play list screen
Press [MENU].
(The unit returns to the condition it was in
before you called up the play list.)
To stop play list play
Press [∫] until the screens clear.
To Next Page
Loading...
