This unit (Right side)
Headphones
3.5 mm stereo
Recording to MDs and cassettes
∫ Analogue recording
You can record to a cassette or MD deck without sound being affected by copy guard if you
use analogue connection.
≥Use a stereo phono cable for analogue connection. (➡ page 33)
∫ Digital recording
You can record the digital signal directly onto an MD.
The signals on DVDs will be converted to 48 kHz/16 bit linear PCM.
Ensure the following conditions are met.
≥There is no copy guard recorded on the disc.
≥The recording equipment can handle a sampling frequency of 48 kHz.
1. Use an optical fiber cable for digital connection. (➡ page 33)
2. When recording DVDs, make the following settings.
3. V.S.S.: OFF (➡ page 19)
3. PCM Down Conversion: Yes (➡ page 43)
3. Dolby Digital/DTS Digital Surround/MPEG
§
: PCM (➡ page 43)
§
MPEG is not available.
Using an optional car adaptor: Part number DY-DC95
For Asia
Note
≥Read the car adaptor’s operating instructions carefully.
≥In the interests of the traffic safety, do not perform operations on the unit or view video
software while driving a vehicle.
≥Do not rest the unit directly on your lap for a long time. It can become hot and cause burns.
Place the unit in a secure position for viewing.
≥You can enjoy sound through your car audio system by connecting a car stereo cassette
adaptor (part number—SH-CDM10A) to this unit’s headphone jack.
Using headphones
Preparations
Turn down the volume before connection, and then adjust the level.
To Next Page
Loading...
