Panasonic Elite Big PAC-i U-200PZH2E8 - Page 123

1-12-2-2-16
1
<Procedure of CZ-RTC5B>
Stop the system before performing these steps.
(1)
Keep pressing the
, and buttons
simultaneously for 4 or more seconds.
The “Maintenance func” screen appears on the LCD
display.
(2)
Press the
or button to see each menu.
If you wish to see the next screen instantly, press the
or button.
Select “8. Detailed settings” on the LCD display and
press the
button.
The “Detailed settings” screen appears on the LCD display.
(3)
Select the “Unit no.” by pressing the
or
button for changes.
(4)
Select the “Code no.” by pressing the or
button.
Change the “Code no.” to “ ” by pressing the or
button (or keeping it pressed).
=91
=90
=92
=93
Electrical component box
XX YYYY
(5)
Select the “Set data” by pressing the or
button.
Select one of the Setting Data “YYYY” by pressing the
or button.
Then press the
button.
XX
YYYY
Flap position
1
2
3
4
5
* Setting data “ ”
Setting data Flap position during operation
Without separate setting
Swing
Move to position
1
and stay
Move to position
2
and stay
Move to position
3
and stay
Move to position
4
and stay
Move to position
5
and stay
NOTE
The flap swings during the operation under “Setting
the Flap Separately”.
At this time, the unselected flaps are moved to the
position
1
.
(6)
Press the button.
The “Exit detailed settings and restart?” (Detailed setting-
end) screen appears on the LCD display.
Select “YES” and press the
button.
281258_EU.indb 24 2016-9-1 13:04:15
If you wish to change the selected indoor unit, follow the
step (2).
<Procedure of CZ-RTC4>
Stop the system before performing these steps.
(1)
Press and hold the
, and buttons
simultaneously for 4 seconds or longer.
(2)
If group control is in effect, press the
button to set.
At this time, the fan at the indoor unit begins and select
the address (unit No.) of the indoor unit operating.
(3)
Designate the item code “
” by adjusting the
Temperature Setting
/ buttons.
=91
=90
=92
=93
Electrical component box
(4)
Press the timer time
/ buttons to select the
desired setting data.
Flap position
1
2
3
4
5
* Setting data “ ”
Setting data Flap position during operation
Without separate setting
Swing
Move to position
1
and stay
Move to position
2
and stay
Move to position
3
and stay
Move to position
4
and stay
Move to position
5
and stay
NOT E
The flap swings during the operation under “Setting
the Flap Separately”.
At this time, the unselected flaps are moved to the
position
1
.
A
°
°
(1)
(5)
(6)
(2)
(2)
(4)
(3)
(4)
YYYY
XX
(5)
Press the
button.
(The display stops blinking and remains lit, and setting is
completed.)
If you wish to change the selected indoor unit, follow the
step (2).
(6)
Press the
button to return to normal remote
controller display.
NOTE
Refer to the Installation Instructions attached to the optional
Wireless Remote Controller.
HOW TO INSTALL WIRELESS REMOTE
CONTROLLER
SM830276-00_欧州向け R32シングル TD＆SM.indb 16 2019/02/27 11:55:10