88
CZ-RWSU3 / CZ-RWSC3
CZ-RWSC3
CZ-RWRC3
CZ-RWSU3
CZ-RWRU3
Start/Stop
Start/Stop
1. Press [Emergency Operation] of the receiver.
Note
• If non-cooling/heating free type is being used, it will beep twice and the operating lamp will light up on the
display; if the timer and standby lamps blink alternately, a conflict between the heating and cooling exists, so the
unit cannot operate in the desired mode. (On models that do not have an Auto function, even if Auto is selected,
it works in the same way.)
• When the local operation is disabled by a central control device or similar cause, and if the Start/Stop , Fan
speed , Flap , Temperature setting / , Mode select or Energy saving button is
pressed, the unit will beep 5 times and the change will not be made.
Use [Emergency Operation] in the following situations when there is an urgent need.
When the remote controller’s batteries have failed.
When the remote controller is broken.
When the remote controller is lost.
*See the following figures regarding Emergency button.
8-10. Emergency Operation
CZ-RWRU3 / CZ-RWRC3
• The OPERATION lamp is lit.
• Auto operation starts. If Auto operation is not possible, the unit starts cooling if the room temperature at the
time is 24 °C or higher; otherwise, the unit starts heating.
• The operation stops if you press [Emergency Operation] again.
8-11
SM830276-00_欧州向け R32シングル TD＆SM.indb 11 19/02/18 11:16:05
To Next Page
Loading...
