Panasonic Elite Big PAC-i U-200PZH2E8 - Page 245

6-7
66
—
——
——
———
1
27 12 17
313188
414199
5101520
61116
21
22 27 32 37
23 33 3828
24 34 3929
25 30 35 40
26 31 36
n
7-segment, 4-digit display for remote controller timer display
The connected unit Nos. are displayed as shown below, using the 7-segment 4-digit (
) display and
the colon.
NOTE
With the outdoor unit maintenance remote controller (when connected to the outdoor unit), the unit remote controller
check functions will not operate.

Display for unit Nos. 1 – 20

Display for unit Nos. 21 – 40

Themeaningofthecolondisplaychangesinthesameway,allowingunitNos.upto80tobedisplayed.

SampledisplaysoftheunitNos.ofconnectedindoorunits
Not lit
Lit
Not lit
Lit
Not lit
Lit
Not lit
Lit
Meaning of display colon
is not displayed.
Meaning of display colon
Not lit
Lit
Not lit
Lit
Not lit
Lit
Not lit
Lit
•DisplayofunitNo.1
•DisplayofunitNos.1and2
•
Display of unit Nos. 1, 2, and 3
•DisplayofunitNos.1,2,3,and4
NOTE
The change of the colon display (between unit Nos. 1-20 to unit Nos. 21-40) occurs automatically
every10seconds.(Howeverthedisplaydoesnotchangeiftherearenohigher-numberunitsconnected.)
To change the display to the higher-number units before 10 seconds have passed, press the (Flap) button.
n
The total compressor operating time is displayed
(in 1-hour units) using 8 digits.
 •Whentherst4digitsaredisplayed,thetop
dotofthecolonisilluminated.(Figure(A))
 •Whenthelast4digitsaredisplayed,thecolon
dot is OFF. (Figure (B))
 •Thedisplayoftherst4digitsandlast4digits
changes automatically after 10 seconds. The display
can also be changed by pressing the
(Flap)
button.
(B)(A)
AA
10: <Compressor’s total operating time>
(A)and(B)aredisplayedalternately.
(The example here (0000, 0062) indicates 62 hours.)
SM830276-00_欧州向け R32シングル TD＆SM.indb 7 19/02/12 15:38:57