Panasonic FP-X0 L40MR - Page 249

Name Boolean Symbol Description
Steps
FP0/FP-e
FP0R
FP
Σ
FP-X
FP-X0
FP2
FP2SH/FP10SH
Special setting instructions
Communica-
tion condi-
tions setting
SYS1
Change the communication conditions
for the COM port or tool port based on
the contents specified by the character
constant.
13
*1 *1
Password
setting
Change the password specified by the
PLC based on the contents specified by
the character constant.
*2 *2
Interrupt
setting
Set the interrupt input based on the
contents specified by the character
constant.
PLC link time
setting
Set the system setting time when a PLC
link is used, based on the contents
specified by the character constant.
*4
MEWTOCOL-
COM response
control
Change the communication conditions of
the COM. port or tool port for
MEWTOCOL-COM based on the
contents specified by the character
constant.
High-speed
counter
operation
mode
changing
Change the operation mode of the high-
speed counter, based on the contents
specified by the character constant.
*3 *3
System
registers “No.
40 to No. 47”
changing
SYS2
Change the setting value of the system
register for the PLC link function.
7
*4
: Available, : Not available, : Not available partially
*1) With FP-X Ver2.0 or later, and FPΣ Ver 3.10 or later, the baud rate can be selected from 300, 600 or 1200 bps.
*2) With FPΣ 32k type, the 8-digit password can be selected.
*3) With FPΣ 32k type and FP-X Ver1.10 or later, it can be used.
*4) Available for FP-X0 L40 and L60 types only.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com