Need help?Do you have a question about the Panasonic GHP and is the answer not in the manual?
Verify installation procedures and related checks.
Verify the quality of installation work performed.
Perform safety checks including insulation and leak tests.
Confirm control wire connections between units.
Essential safety and operational precautions before proceeding.
Step-by-step guide for conducting the test run.
Configure the gas type setting for specific fuel gas.
Review and confirm initial system configurations.
Define system and outdoor unit addresses for communication.
Review initial system settings like addresses and models.
Configure system and outdoor unit addresses.
Perform checks before starting the test run.
Verify refrigerant tubing and control cable connections.
Perform auto or manual address setting operations.
Configure parameters for test run operations.
Set outdoor unit test run and forced operations.
Control forced valve opening, water circulation, air bleeding, and bypass valve.
List of diagnostic codes for GHP systems.
List of diagnostic checks for U-10MES2E8 units.
Steps to prepare for the test run.
Set addresses using the high-spec wired remote controller.
Set test run using CZ-RTC5A.
Set test run using CZ-RTC4.
Table for self-diagnosis and alarm display interpretation.
Perform functional checks on the system.
Check outdoor unit functions like test run and rotation speed.
Check basic performance of indoor/outdoor units and note data.
Installation, function, engine, and data collection checks.
General| Brand | Panasonic |
|---|---|
| Model | GHP |
| Category | Air Conditioner |
| Language | English |
To Next Page