6-35
6.9 GT32-E
6.9.1 General Specifications (GT32-E)
Item
Specifications
GT32M-E GT32T-E
Rated voltage 24 V DC
Operating voltage range 21.6 to 26.4 V DC
Power consumption 4.8 W or less (200 mA or less) 7.2 W or less (300 mA or less)
Insulation method of
power supply part
Transformer insulation
Ambient temperature -20 to +60 C
Ambient humidity 10 to 90% RH (at 25 C, non-condensing)
Storage temperature -20 to +60 C
Storage humidity 10 to 90% RH (at 25 C, non-condensing)
Breakdown voltage
Note2)
Between [power supply terminals] and [case]
500 V AC for 1 minute, Cutoff current 10mA (at default setting)
Insulation resistance
Between [power supply terminals] and [case]
100 M or more, 500 V DC, measured with megohmmeter (at default
setting)
Vibration resistance
5 to 8.4 Hz half amplitude 3.5 mm
8.4 to 150 Hz acceleration 9.8 m/s2,
10 sweeps each in X, Y and Z directions (1 octave/min)
Shock resistance 147 m/s
, 4 times on 3 axes
EC Directive applicable EN61131-2 (EMC Directive)
Noise immunity
1000 V [P-P] or more, Pulse width 50 ns, 1
s between power supply
terminals (based on in-house measurements)
Note3)
Electrostatic discharge
resistance
6kV
(Contact Discharge, EN61000-4-2 Level 3)
Protective construction
IP67 (Initial value, evaluated by us)
Dustproof and drip-proof from front panel only (packing used on panel
contact surface)
Note4)
Weight Approx. 470 g
Note1) When it is installed in a horizontal orientation (installed to make the liquid crystal face be topside),
the usable range is -20 to +55 C.
Note2) Not isolated between the USB port, COM port and the internal digital circuit.
Note3) When using our exclusive cable.
Note4) When reattaching, replace waterproof packing.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
