1 Signal ground SG -
2 Send data SD GT→External device
3 Receive data RD GT←External device
4 Not connected N.C. -
5 +5 V (+5V) -
Note:
• The +5V of Pin 5 is reserved for the FP Programmer II. It should not be used for any other application.
If using it, there is a restriction on the ambient temperature. The pin 5 of GT01 is N.C.
2.3.2 USB Port
USB connection
Communication with our software such as GTWIN becomes available by connecting to a PC with a USB
cable.
Functions enabled by USB connection
• Through function using our PLCs
• Screen transfer (The communication in a speed approximately 3 times of the one with the Ethernet
connection is possible.)
Note: If more than one programmable display unit or AE20 are connected to a PC using the USB
port, the communication is not available.
To Next Page
Loading...
