Panasonic GT21

5-12
Code No.
Content
Cause and solution
**1025
General-purpose
memory shortage
General-purpose memory shortage in the destination PLC.
**1027
Remote mode error
The PLC (FP2/FP2SH) is set to the RUN mode. Change to the
REMOTE mode or PROG. mode.
**102D
Forced operation error
Check if a device that cannot be forcibly operated in the PROG.
mode has been forcibly turned on or off.
**1040
The record area for
logging was
overwritten.
A SD memory card is not inserted.
Check the SD memory card slot.
**1041
Data cannot be written into the SD memory card. Check whether
the SD memory card is not write-protected.
**1042
As the memory of the SD memory card has been exhausted.
Delete some data in the SD memory card or prepare a new SD
memory card.
**1044
The setting to stop writing to SD memory card has been set.
Cancel the writing stop setting.
**1043
SD memory card
writing error
The setting to stop writing to SD memory card has been set.
Cancel the writing stop setting.
**1045
The record area for
logging cannot be
reserved in the
SRAM.
Transfer all data.
**10A0
FROM write error
The firmware file loaded from a SD card is damaged.
Recreate the file in the SD card.
**1100
Ethernet IP address
setting error
The IP address for Ethernet is not specified correctly. Check the
IP address for the GT.
**1101
Ethernet subnet mask
setting error
The subnet mask for Ethernet is not specified correctly. Check
the subnet mask for the GT.
**1102
Ethernet default
gateway setting error
The default gateway for Ethernet is not specified correctly.
Check the default gateway for the GT.
**1103
Ethernet port number
setting error
The port number for Ethernet is not specified correctly. Check
the port number error for the GT.
**1060
Index register value
error
The device value for index modifier is out of the setting range.
Check the setting value.
**1080
Start time device
value error
The value at the start of the line graph function is out of the
setting range. Check the setting value.
**2000
Connected GT
designation area error
The bit corresponding
to the connected GT
in the connected GT
designation area.
The bit in the connected GT designation area corresponding to
the station number of the connected GT is not on.
Check the connected GT designation area.