Panasonic GT21

3-4
3.1.2 Restriction According to Mounting Directions
If the unit is being installed in a horizontal orientation, or our Programmer II and C-NET adaptor are
being connected to the TOOL port, note that the ambient usage temperature should be as below.
Model
name
Condition
Ambient
temperature
GT11
Vertically installed
0 to 45 C
Programmer II
C-NET adapter
GT21
Horizontally installed
Programmer II
C-NET adapter
GT32
Horizontally installed
0 to 40 C
GT03-E
GT32-E
Horizontally installed
-20 to 55 C
Vertically installed
Note) When installing the unit aslant, the restriction is the same as the one when installing horizontally.
3.1.3 Installation Space
Applicable panel thickness
A panel with a thickness of 1.0 to 5.0 mm should be used.
Use a panel that is strong enough not to be warped.
Clearance when the GT is installed
When installing other parts to the panel or wiring cables to it, provide a clearance around the panel to
prevent cables from being damaged and to facilitate the installation work.
When performing installation work, make sure to observe the following.
 Never obstruct the slits of the GT unit.
 Make sure that no foreign matter enters inside through the slits. If conductive foreign matter enters
inside, it may malfunction or product failure.
Model name
Clearance
Clearance on the surface
to connect the screen
transfer cable
Clearance on the
mounting surface when
using a SD memory card
GT01
GT11
GT21
30 mm or more
(50 mm or more
recommended)
20 mm
-
GT02L
GT03M-E
60 mm
-
GT02
GT05
GT03T-E
GT12
GT32
GT32-R
GT32-E
60 mm
40 mm or more
* It should be 40 mm or more when using a SD memory card.