Panasonic GT32

4-35
4.5.4 Communication Settings of PLC using FPWIN GR7
Please read below to make PLC communication settings using the FPWIN GR7.
1. Select "Options (O)" > "FP7 Configuration (C)" > "Built-in SCU".
2. Make the communication settings.
Set the communication settings of the communication port connected to the GT to be the same as those
of the GT.
<Default>
Communication Mode: MEWTOCOL-
COM
Baud rate: 9600 bps
Data length: 8 bits
Parity: Odd
Stop bit: 1 bit
Note) The baud rate can be changed from 9600 bps.
When changing it, it is necessary to make the both baud rates of FP series and GT series be the same.