1-3
Saving various data with a SD memory card (Model equipped with SD memory card slot）
Various data can be saved and read out with a SD memory card.
Power can be supplied to the 5 V DC type with only one communication cable.
The power is supplied from the TOOL port of a PLC, therefore, the wiring man-hours can be significantly
reduced.
Three methods are available to switch the screen.
Switching by the instruction from PLC
The screens can be switched by writing to the “basic communication area” from the PLC ladder program.
Switching with the touch-screen operation
The screens can be switched on the GT by using the “function switching parts” provided in the parts
library of the GTWIN that has a function to switch the screens.
Switching automatically
The GT man unit has an “Auto-paging” function in the configuration setting that automatically switches
the screen to a specified screen number when a certain period of time has elapsed. This function can be
used to switch screens automatically.
To Next Page
Loading...
