29
(ENG) SQT0665
Using [Link to Cell] with a wireless access point
connection
Check if the wireless access point you are using is compatible with WPS
j If the wireless access point is compatible with WPS:
Proceed to the following [WPS Connection]
j If the wireless access point is not compatible with WPS:
“Searching for wireless access points to set up a connection” (l 30)
1 Press Wi-Fi button on this unit.
≥ When the Wi-Fi button is pressed for the first time, a message is displayed. Touch [YES], and
proceed to step 4.
2 Touch [Wi-Fi Setup] and select [Wireless Settings].
3 Touch the part with no display of a wireless
access point.
4 Touch [WPS Connection].
5 Set the wireless access point to waiting for WPS.
≥ For further details, please read the operating instructions for the
wireless access point. (When using a tethering connection, please
read the operating instructions for the smartphone.)
≥ A message is displayed when the connection is complete. Touch
[ENTER], and exit [Wireless Settings]
≥ A message is displayed when the connection attempt fails. Touch
[ENTER], and set the connection again.
6 Connect the smartphone to a wireless access point.
7 Touch [Link to Cell] and start up the smartphone application “Image App”.
≥ When the connection is complete, images of this unit is displayed on the smartphone screen.
≥ For information on how to set a PIN code, refer to the Owner’s Manual (PDF format).
≥ When this unit is connected to a wireless access point, you can also use NFC to remotely operate
this unit with the smartphone via the wireless access point. For details, refer to “Using [Link to
Cell] with a wireless access point connection” in the Owner’s Manual (PDF format).
[WPS Connection]
HC-V270PP-SQT0665_mst.book 29 ページ ２０１４年１１月４日 火曜日 午前１１時４２分
To Next Page
Loading...
