- 67 -
Message is displayed when this unit is moved rapidly.
When “CAMERA PANNING IS TOO FAST.” appears, move the unit slowly while recording.
≥ Message will not appear while pausing the recording. (Message will appear even if it is pausing
the recording if [DEMO MODE] is set to [ON].)
This is for reducing the wind noise coming into the built-in microphones.
≥ Switch to Manual Mode. (l 49)
≥ This function’s default setting is [ON].
≥ When switching to Intelligent Auto Mode/Intelligent Auto Plus Mode, [WIND CUT] is set to [ON],
and the setting cannot be changed.
≥ You may not see the full effect depending on the recording conditions.
Recording setting of the built-in microphone can be adjusted.
≥ [MIC SETUP] will become [STEREO MIC] when the [REC FORMAT] is set to [MP4/iFrame].
[SHOOTING GUIDE]
: [RECORD SETUP] # [SHOOTING GUIDE] # [ON]
[WIND CUT]
: [RECORD SETUP] # [WIND CUT] # [ON]
[MIC SETUP]
: [RECORD SETUP] # [MIC SETUP] # desired setting
[STEREO MIC]: Sound from two directions is recorded in 2 ch by forward-facing
stereo microphones.
[ZOOM MIC]: Sound is recorded with changing the directionality in conjunction
with the zoom operation. Sounds near the front of the unit are
recorded more clearly if you zoom in (close-up) and surrounding
sounds are recorded more realistically if you zoom out (wide angle).
MENU
To Next Page
Loading...
