- 114 -
Using a smartphone, you can perform record/playback operations from a remote location or upload
motion pictures and still pictures recorded in this unit on SNS (Social Networking Service).
A When connecting directly to a smartphone
B When connecting to a wireless access point
≥ Refer to [Help] in the “Image App” menu about how to operate.
Preparations before using [Remote Ctrl]
1 Install the smartphone application “Image App” on your smartphone. (l 141)
2 Check if the smartphone is an Android (NFC-compatible), Android (non-NFC-
compatible), or iOS device.
≥ If the smartphone is NFC-compatible, the NFC mark is displayed when you start up “Image App”.
Using NFC, you can easily set up a direct connection between this unit and the smartphone.
∫ If the device is Android (NFC-compatible)
Use NFC to set up a direct connection between this unit and the smartphone.
≥ Proceed to “Using [Remote Ctrl] with a direct connection”. (l 116)
Wi-Fi [V270]
[Remote Ctrl]
≥ You need to turn on the Wi-Fi function of your smartphone.
≥ Do not remove the SD card during remote operations.
Caution:
Be sure to pay special attention to the privacy, the likeness rights, etc. of the subject when you use
this function. Use at your own risk.
Setting up a direct Wi-Fi connection between this unit and a
smartphone
To Next Page
Loading...
