EasyManua.ls Logo

Panasonic HDC-SD1 - Recording; Built-in flash

Panasonic HDC-SD1
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
56
VQT1D38
Recording
Use the built-in flash in order to record still
pictures in dark places.
¬
Rotate the mode dial to select .
1 Press the cursor button. Then
move the cursor button down to
display the icon shown in the
illustration.
2 Move the cursor button left to
select [ß].
Each time the cursor button is pressed left,
the indication changes by one setting in the
following order: [FLASH ON] >
[FLASH AUTO] > [FLASH OFF]
When the PHOTO SHOT button is pressed
halfway, the flash indicator will appear in
the bottom left corner of the screen.
[FLASH ON]: ß
[FLASH AUTO]: ßA
[FLASH OFF]:
When [FLASH AUTO] is set, the ambient
brightness is automatically detected, and
the flash will activate only when necessary.
(If the flash is not necessary, the [ßA]
indicator will not appear when the
PHOTO SHOT button is pressed halfway.)
This function’s default setting is
[FLASH AUTO].
3 Press the PHOTO SHOT button.
The flash is activated and the picture will be
recorded.
When the flash is not used
Set the flash to [FLASH OFF].
Do not block the flash with your hand or by
other means.
The unit automatically determines if the flash is
necessary even when it has been set to
[FLASH OFF] by detecting the ambient
brightness. (If it determines that the flash is
necessary, the [ ] indication lights up in red
when the PHOTO SHOT button is pressed
halfway.)
If the [ß] indication etc. flashes or is not
displayed when the PHOTO SHOT button is
pressed halfway, the flash is not activated.
The available range of the flash is approx. 1 m
to 2.5 m in dark places. Pictures will appear
dark or reddish when they are recorded by
using the flash at distances greater than 2.5 m.
Using the flash fixes the shutter speed of 1/750
or faster to 1/500.
The picture may become out of focus in dark
places. If so, adjust the focus manually.
The picture may appear dark if the flash is lit in
front of a white background.
Set the flash to [FLASH OFF] where using a
flash is prohibited.
If the flash will be activated a large number of
times, it may take longer to charge it.
Built-in flash
VQT1D38_EG_ENG.book 56 ページ 2007年1月27日 土曜日 午後3時17分

Table of Contents

Related product manuals