HL-BD82S
17
5.14. Fault Codes
If the fault involves safety requirements or the correct oven functionality, any activity must be stopped until the fault is removed.
Every alarm condition can be reset manually by turning the cooking mode knob in the OFF position and the temperature knob in the
preset position. Of course, the cause of the failure must be first removed.
Whenever the fault doesn’t affect the whole oven functionality, allow the user to work:
• If the latch doesn’t work, ordinary cooking activities may run if the door is fully unlocked.
• In case of a F19 keyboard failure, allow to work manually in the main cavity only.
Every fault must have a time-out to be declared, to prevent false alarms. When a fault occurs, if the control can detect the failure, an
error number must be displayed, as shown in the table below.
Faults N°
Single oven RTD temperature sensor failure F01 Err
Single oven motorized latch or switches failure F03 Err
Single oven runaway temperature condition 650°F F05 Err
Single oven runaway temperature condition 950°F F07 Err
Short circuit on display board microcontroller pins F09 Err
Short circuit on display board F10 Err
EEPROM data access failure on display board F11 Err
Electronic control overheating F12 Err
Meat probe error (check harness, option jumper) F13 Err
Communication problem between the boards F14 Err
TC keyboard failure F19 Err
To Next Page
Loading...
