HL-BD82S
6
4.2.2. Configuration
4.2.2.1. Meat Probe
• The meat probe must be inserted when the message Prob
OFF is displayed. If everything is fine, the probe temperature
will be displayed instead of OFF.
Important: if the temperature display remains [OFF] quitting
the manual test, the meat probe option will not be enabled.
4.2.2.2. Functions
• Continue the test until S00 step is displayed: the control now
starts the steps to check all the oven outputs and inputs. The
active triangle near the tESt writing indicates the cavity
under test.
• Always press [+] button to proceed to the following
steps.
4.2.2.3. How to check Oven hardware
• S01: oven lights.
• S02: cooling fan.
• S03: convection fan. (ONLY FOR CONVECTION CAVITY)
• S04: check that no heating elements are energized. The
double line break relay must be open.
• S05: bottom element (3000W @240v 12,5) & (2253W
@208v 10,8A)
• S06: top element (3500W @240v 14,6) & (2629W @208v
12,6)
• S07: ring element
For single fan (2500W @240v 10,4) & (1877W @208v
9,0)
For double fans (2x1300W=2600W @240v 10,9) &
(1950W @208v 9,4)
Convection fans are also running. (ONLY FOR CON-
VECTION CAVITY).
• S08: additional element (1030W @240v 4,3A) & (775W
@208v 3,7A)
4.2.2.4. Dial Function
• S09: cooking mode selector. The display automatically
shows the off position value:
• Turn the knob clockwise and check that the values corre-
spond to the ones in the following table:
Once back in the off position, the control shows automati-
cally the step number again.
4.2.2.5. Temperature Function
• S10: temperature selector. The display automatically shows:
• (Default) in preset position.
• Turn the knob clockwise and verify that the temperature
changes between 170°f and 550°f. Verify that in clean posi-
tion the display shows:
• Once back in preset position, the control shows automati-
cally the step number again.
4.2.2.6. Finalization
• S11: press [options] to verify the temperature value
actually measured by the electronics. Press it again, then +
to come back to the step number.
• When the display shows the following message:
• Hold [options] and [fast preheat] to quit the manual
test and come back to the standard working mode.
Code ENGLISH
Multifunction
C00 Off
C01 Convection bake
C02 Convection broil
C03 Convection roast
C04 Fast preheat
C05 Bake
C06 Broil
C07 Dehydrate
C08 Self-clean
To Next Page
Loading...
