R : Indicates areas of the camera image where motion was not detected
R
: Indicates areas of the camera image where image detection is disabled
R Tap to change the number of areas displayed on the screen.
5 When finished, tap [Set].
Motion sensitivity
You can adjust the sensitivity of the camera’s motion detection features.
1 From the [HomeHawk] app home screen, tap ® [Settings].
2 Tap [Camera Settings] and select the desired camera.
3 Tap [Detection] ® [Motion Sensitivity].
4 Select the desired setting.
– [High]: The sensors are very sensitive to changes, i.e., even a small change will trigger the
sensors.
– [Normal]: The sensors are moderately sensitive to changes.
– [Low]: The sensors are somewhat sensitive to changes.
– [Very Low]: The image sensor is only slightly sensitive to changes, i.e., a large change is required
to trigger the sensor.
5 When finished, tap [OK].
Camera SD cards
SD card capacity and total recording time
The following recording times apply when images from one camera are recorded. All times are
approximate.
– 4 GB card: 4 hours
– 8 GB card: 9 hours
– 16 GB card: 18 hours
– 32 GB card: 36 hours
– 64 GB card: 72 hours
– 128 GB card: 145 hours
– 256 GB card: 290 hours
– 512 GB card: 582 hours
– 1 TB card: 1165 hours
Note:
R SD cards larger than 1 TB cannot be used.
R The times listed here are calculated theoretically. Actual recording time may vary.
R The times listed here apply during the following condition.
– [Resolution] is set to [HD (1280x720)] ( “Changing the camera resolution”, Page 112)
R The file system and other information is stored on the SD card, therefore the card’s actual available
capacity will be less than the card’s noted capacity.
104
Using a shelf, floor, and window camera
To Next Page
Loading...
