7 When prompted, enter a name for the camera and mobile device, and then tap [OK].
R The camera name setting is used by your mobile device to identify the camera. This is useful when
you have multiple cameras.
R The mobile device name setting is used to identify your mobile device. This is useful when
performing certain operations, such as deregistering.
8 When [Congrats!] is displayed, tap [Explore HomeHawk].
R A screen explaining how to insert an SD card into the camera is displayed.
If you will use an SD card to record images, follow the on-screen instructions and insert an SD
card into the camera.
R A screen asking you to set the home position of geo-fencing ( “Automatic Mode Switching”,
Page 87) is displayed, tap [Set Current pos as Home] ® [OK].
R The app’s home screen is displayed when initial setup is completed.
Basic Setup
1 Enter the password for the wireless network and then tap [Next].
2 Depending on the type of mobile device that you use, proceed as follows.
Android users:
Go to step 3.
iOS 11.0 and later users:
Tap [Join].
iOS 10.x users:
Change your mobile device’s wireless network setting temporarily so that it connects to the camera
directly.
R Open your mobile device’s [Settings] app, tap [Wi-Fi], select “Pansonic_Camera”, enter
“12345678” as the password, and then tap [Join].
Note:
R Your mobile device starts searching for the camera.
R When [Linking] is displayed, wait for up to about 3 minutes until the camera is connected to your
wireless network and mobile device.
3 Press the SETUP button on the camera for about 2 seconds until the camera beeps.
R The camera’s LED indicator starts blinking in green.
4 When prompted, create a login password for the camera, and then tap [Next].
5 When prompted, enter a name for the camera and mobile device, and then tap [OK].
R The camera name setting is used by your mobile device to identify the camera. This is useful when
you have multiple cameras.
R The mobile device name setting is used to identify your mobile device. This is useful when
performing certain operations, such as deregistering.
6 When [Congrats!] is displayed, tap [Explore HomeHawk].
R A screen explaining how to insert an SD card into the camera is displayed.
If you will use an SD card to record images, follow the on-screen instructions and insert an SD
card into the camera.
R A screen asking you to set the home position of geo-fencing ( “Automatic Mode Switching”,
Page 87) is displayed, tap [Set Current pos as Home] ® [OK].
R The app’s home screen is displayed when initial setup is completed.
Registering other mobile devices to the floor camera
Confirm the following before you begin.
– Make sure you have installed the [HomeHawk] app on your mobile device
– Make sure your wireless router and the camera are turned on
69
Using a shelf, floor, and window camera
To Next Page
Loading...
