Floor camera setup
Floor camera setup (overview)
There are 3 basic steps you need to perform in order to connect to the camera from your mobile device.
1 Download the app
Download the [HomeHawk] app to your mobile device.
See “Downloading the [HomeHawk] app (overview)”, Page 20.
2 Set up the camera
Use the [HomeHawk] app to configure the camera to connect to your wireless router, and then
register your mobile device to the camera.
See “Floor camera initial setup”, Page 67.
3 Register additional mobile devices (optional)
You can register additional mobile devices to the camera, for a total of 8.
See “Registering other mobile devices to the floor camera”, Page 69.
Floor camera initial setup
Before you begin
Confirm the following before you begin.
– Make sure you have installed the [HomeHawk] app on your mobile device
– Make sure your wireless router and the camera are turned on
– Make sure your mobile device is connected to your wireless router
– Make sure your mobile device can connect to the Internet
Note:
R If you have completed this procedure and want to register another mobile device to the camera, see
“Registering other mobile devices to the floor camera”, Page 69.
R If you experience trouble while performing this procedure, refer to the information in “Initial setup by
WPS”, Page 186 and “Initial setup by Basic Setup”, Page 188.
Initial setup
1 Start the [HomeHawk] app by tapping its icon (shown below).
R The end-user license agreement is displayed the first time you start the app.
R Confirm all of the displayed permission screens and agree as necessary.
R Select your country or region if displayed, and then tap [Next].
67
Using a shelf, floor, and window camera
To Next Page
Loading...
