23
(ENG) SQT0251
3 Hook the Head Mount to your ears
firmly so that the camera unit will be
positioned on the left side of your
face.
4 Adjust the size of the Head Mount,
and push down the lock lever to the
LOCK side.
≥ Adjust by slowly pulling the Head Mount (R)
sideways.
≥ If you adjust in such a way that the camera unit comes into close contact with the cheek, you can
record less blurry images.
5 Hold the camera holder, and adjust
the direction of the lens.
≥ To loosen the adjustment knob, rotate it
towards 1. To tighten the adjustment knob,
rotate it towards 2.
≥ If the direction of the lens cannot be changed,
loosen the adjustment knob slightly and tighten
it after adjusting the direction of the lens.
≥ If the camera unit is shaky, tighten the
adjustment knob.
∫ How to remove the camera
Hold the camera holder as shown in the figure, and remove the
camera unit in the direction of the arrow.
≥ Do not touch the lens or pull the camera/main unit connection cable while attaching or removing.
≥ When adjusting the size of the Head Mount and the tightness of the Headband, do so slowly
without applying too much force.
≥ If the adjustment knob comes off, attach it as indicated in the
right figure.
We recommend you make a test recording to check the settings such as the [ANGLE OF VIEW],
[LEVEL SHOT], [IMAGE STABILIZATION] and [WHITE BALANCE] before recording.
≥ Please refer to “Owner’s Manual (PDF format)“ for details.
Things to check after putting on this unit
D Adjustment knob
E Camera holder
HX-A500-SQT0251_mst.book 23 ページ ２０１４年４月１４日 月曜日 午後６時１５分
To Next Page
Loading...
