VQT3P46 29
SETUP
3 Use the USB cable (supplied) to connect the camera and the AC
adaptor, and then connect the AC adaptor to a power outlet.
h Recharging takes place only when the camera is turned off or is in the
sleep mode (see page 36 in the Operating Instructions (PDF format)).
Recharging does not take place when the camera is in the recording
mode or playback mode.
h The unit is in the standby condition when the AC adaptor is
connected. The primary circuit is always “live” as long as the AC
adaptor is connected to an electrical outlet.
h Do not use any other AC adaptors except the supplied one.
h Do not use any other USB cables except the supplied one.
<During charging...>
h The status indicator flashes red at 0.5-second intervals if the battery
pack is defective or is not installed correctly. Make sure that the
battery pack is correctly installed.
h If the battery pack still fails to recharge, it is possible that there is a
malfunction in the camera, the battery pack or the AC adaptor. In case
the status indicator is flashing fast or slow, please see page 178 in the
Operating Instructions (PDF format).
h When charging is completed, the status indicator turns off.
h The charging time is approx. 120 minutes.
h Use only the supplied USB cable. Operation is not guaranteed if
a different USB cable is used.
h The AC adaptor is for this camera only. Do not use it with other
devices.
To AC adaptor
AC adaptor
2
1 Open
3 To p ow e r
outlet
Status indicator
To Next Page
Loading...
