14
Location of Controls (continued)
NOTE:
The above illustration is for reference only.
Re-position the drip
tray by clicking back
onto the legs.
Drip Tray
1. Before using the oven, the drip tray must be fitted as it
collects excess water during cooking. The drip tray should
be removed and cleaned on a regular basis.
2. Fit the drip tray by holding with both hands and clicking
onto the front legs of the oven.
3. To remove the drip tray, hold with both hands and gently
ease forward. Wash in warm soapy water. Re-position the
drip tray by clicking back onto the legs.
4. DO NOT USE A DISHWASHER TO CLEAN THE DRIP TRAY.
Front View Rear View
32
1
1. Control panel
2. Drip tray
3. Water tank
6
4 5
4. Air vent exhaust
5. Warning label
6. Identification label
Water Tank
Carefully remove the water tank from the oven. Remove the lid and fill with pure water (do not
use mineral water). Replace the lid and position back in the oven. Ensure the lid is closed tightly
and securely positioned, otherwise leakage may occur. It is recommended to clean the water
tank in warm water once a week.
F0003CM50CP_Eng_审查.indd 14 2023/3/30 12:47:30
To Next Page
Loading...
