10. Clean the conveyor rollers and exit roller
.
i. Use the Roller Cleaning Paper (page 9) to wipe the dirt from the surfaces of the rollers.
ii. Press the Start/Stop button (
) on the scanner to rotate the rollers a small amount.
iii. Repeat these steps until all surfaces of all rollers are cleaned.
11. Close the ADF door (
page 34).
12. Press the back button (
) to exit Cleaning Mode.
Note
• Cleaning Mode can be started from User Utility
. For details, refer to the User Utility help.
9.2.4 Cleaning Mode
75
To Next Page
Loading...
