6.11. Selecting the Display Language
· To exit the operation, press any time.
· *1 You can select one of 10 languages. If you set a language you cannot read, reset the handset to its initial settings.
Press MENU → DOWN → RIGHT → UP → RIGHT → 4-digit Handset PIN → UP → OK
All handset setting will be reset to their initial settings, however, the Phonebook data will be saved.
6.12. Select Dialling Mode (Tone/Pulse)
You can change the dialling mode to tone or pulse depending upon your network service. If you have a touch tone service,
select tone. If you have rotary or pulse service, select pulse.
· To exit the operation, press any time.
· *1: The factory preset is 0000.
6.13. Select Flash Timing
You can change the duration of the flash timing depending on the requirements of your PBX requirements.
· To exit the operation, press any time.
· *1: The factory preset is 0000.
For Service Hint: Refer to Select Flash Timing (P.64)
17
KX-TCD4 10RUM / KX-TCD410RUS / KX-TCD412RU M / KX-TC D412RUS / KX-A141RUM / KX-A141RUS / KX-A142RUM / KX-A142RUS
To Next Page
Loading...
