Features Summary
60
Code Feature & Display Settings How the unit operates
You can confirm the status of the
other party’s machine.
●
If the ring back tone continues, the
other party’s machine may not be
a facsimile or may have run out of
paper. Check with the other party.
●
The connecting tone volume
cannot be adjusted.
#76
Setting the connecting tone
If you often have trouble when
sending a fax, this feature allows
you to hear connecting tones: fax
tone, ring back tone and busy tone.
CONNECTING TONE
MODE=ON [±]
ON
OFF
#68
Setting the Error Correction
Mode (ECM)
To send a fax even if there is static
interference on the telephone line.
ECM SELECTION
MODE=ON [±]
ON
OFF
This feature is available when the
transmitting/receiving stations are
ECM compatible.
#80
Resetting advanced features to
their default settings
SET DEFAULT
RESET=NO [±]
YES
NO
1. Follow steps 1 and 2 above.
2. Press
+ or - to select “YES”.
3. Press w.
4. Press
w again.
5. Press
p.
(The default setting is in bold type.)
#79
Saving on toner consumption
TONER SAVE
MODE=OFF [±]
ON
OFF
“ON”: The toner cartridge will last
longer.
●
This feature may lower the print
quality.
How to set menu options
Advanced features (cont.)!
Note:
●
Step 3 may be slightly different depending on the
feature.
●
See page 55 for more details.
1. Press p.
2. Press ( or ) until the following is
displayed:
then press w and press ( or )
until the desired feature is displayed.
ADVANCED MODE
PRESS SET
3. Press + or - until the desired setting is
displayed.
4. Press w.
5. Press p.
Programming table (cont.)
To Next Page
Loading...
