Panasonic KX-FLB881

9. Programmable Features
52
Changing the password for
feature programming via
remote operation
{#}{1}{5}{5}
1. {MENU} i {#}{1}{5}{5} i {SET}
2. Enter the current password. i {SET}
L The default password is “1234”.
3. Enter a new 4-digit password using 0–9. i {SET}
4. Enter the new password again. i {SET} i {MENU}
Note:
L If you forget your current password, “0101” can always be entered in step
2 to continue changing the password.
L This password is also used for feature programming via web browser.
Setting the ringer pattern
{#}{1}{6}{1}
{1} “A” (default)
{2} “B”
{3} “C”
Changing the ring count in
FAX ONLY mode
{#}{2}{1}{0}
{1} “1”
{2} “2”
{3} “3” (default)
{4} “4”
{5} “5 EXT. TAM” (External Telephone Answering Machine)
Setting the Caller ID list to
print automatically
{#}{2}{1}{6}
{0} “OFF” (default): The unit will not print the Caller ID list, but will keep records
of the information for the last 30 callers.
{1} “ON”: The unit will print the Caller ID list automatically after every 30 new
calls (page 47).
Setting the time adjustment
{#}{2}{2}{6}
Using this feature, the unit’s date and time setting will be automatically adjusted
when caller information is received.
{1} “AUTO” (default): The date and time setting will be automatically adjusted.
{2} “MANUAL”: Deactivates this features.
Setting the recording paper
size in the paper input tray
{#}{3}{8}{0}
{1} “LETTER” (default): Letter size paper
{2} “A4”: A4 size paper
{3} “LEGAL”: Legal size paper
Setting the waiting time for
the power save mode
{#}{4}{0}{3}
To set the length of time before the unit enters the power save mode.
{1} “5min” (default): 5 minutes
{2} “15min”: 15 minutes
{3} “30min”: 30 minutes
{4} “1h”: 1 hour
Note:
L During the power save mode, the unit needs to preheat the fuser unit before
printing.
Holding the previous contrast
setting
{#}{4}{6}{2}
{0} “DISABLED” (default): Deactivates this feature.
{1} “ENABLED”: The unit will hold the previous setting.
Note:
L The previous setting will be held individually for copying and sending faxes.
Setting the default operation
mode
{#}{4}{6}{3}
To select the default operation mode when the selected time of the mode timer
(feature #464) passes.
{1} “COPY” (default): Copy mode is selected as default.
{2} “FAX”: Fax mode is selected as default.
Note:
L You cannot select the scan mode using this feature.
Feature/Code Selection