2. Preparation
21
Volu me
2.6 Adjusting volume
Important:
L Before adjusting volume, set the operation mode
to fax mode. If the {FAX} light is OFF, turn it ON
by pressing {FAX}.
Ringer volume
While the unit is idle, press {V} or {^}.
L If there are any documents in the document
entrance, you cannot adjust the volume. Confirm that
there are no documents in the entrance.
To turn the ringer OFF
Press {V} repeatedly to display “RINGER OFF= OK?”.
i {SET}
L The unit will not ring.
L To turn the ringer back ON, press {^}.
Ringer pattern
L You can select one of 3 ringer patterns (feature #161
on page 56).
Monitor volume
While using the monitor, press {V} or {^}.
Initial Programming
2.7 Date and time
1 {MENU} i {#}{1}{0}{1} i {SET}
D:|01/M:01/Y:07
TIME: 00:00
2 Enter the current date/month/year/hour/minute by
selecting 2 digits for each. Press {*} repeatedly to
select “AM” or “PM”, or 24-hour time entry.
Example: 10 August, 2007 10:15 PM (12 hour
clock format)
1. Press {1}{0} {0}{8} {0}{7} {1}{0} {1}{5}.
D:|10/M:08/Y:07
TIME: 10:15
2. Press {*} repeatedly to select “PM”.
3 {SET}
4 Press {MENU} to exit.
Note:
L The other party’s fax machine will print the date and
time on the top of each page you send according to
your unit’s date and time setting.
L After setting the date and time, if the unit is in the
copy mode, change it to the fax mode by pressing
{FAX}. You can check your unit’s date and time
setting on the display.
To correct a mistake
Press {<} or {>} to move the cursor to the incorrect
number, and make the correction.
If you have subscribed to a Caller ID service
If feature #114 is set to “NEW ZEALAND”, the date and
time will be automatically set according to the received
caller information.
L If the time has not previously been set, Caller ID will
not adjust the clock.
{SET} {V}{^}
{FAX}
{SET}{FAX}{<}{>}
{MENU}
FLB882CX-PFQX2773ZB-OI-en.book Page 21 Friday, October 5, 2007 11:45 AM
To Next Page
Loading...
