9. Programmable Features
62
9.4 Copy features
Feature/Code Selection
Changing the default copy
resolution
{#}{4}{6}{1}
To change the default resolution setting for copying.
{1} “TEXT/PHOTO”: For documents containing both text and photographs.
{2} “TEXT” (default): For documents containing only text.
{3} “PHOTO”: For documents containing photographs, shaded drawings, etc.
Setting the output tray to use
for copying
{#}{4}{6}{6}
You can select the output tray that will be used for copying.
{1} “#1” (default): Upper output tray (Up to approx. 100 sheets)
{2} “#2”: Lower output tray (Up to approx. 50 sheets)
Holding the previous page
layout setting
{#}{4}{6}{7}
{0} “DISABLED” (default): Deactivates this feature.
{1} “ENABLED”: The unit will hold the previous setting.
Holding the previous zoom
(enlargement / reduction)
setting
{#}{4}{6}{8}
{0} “DISABLED” (default): Deactivates this feature.
{1} “ENABLED”: The unit will hold the previous setting.
Holding the previous collate
setting
{#}{4}{6}{9}
{0} “DISABLED” (default): Deactivates this feature.
{1} “ENABLED”: The unit will hold the previous setting.
FLB882CX-PFQX2773ZB-OI-en.book Page 62 Friday, October 5, 2007 11:45 AM
To Next Page
Loading...
