50
KX-FT931LA-B
8 Installation Instructions
8.1. Installation Space
The space required to install the unit is shown below.
The dimensions given are necessary for the unit to operate
efficiently.
Note:
• Avoid excessive heat or humidity.
• Use the unit within the following ranges of temperature and
humidity.
• Ambient temperature: 5°C to 35°C
• Relative humidity: 20% to 80% (without condensation)
• Power cord length should be less than 5 meters. Using a
longer cord may reduce the voltage or cause malfunctions.
• Avoid direct sunlight.
• Do not install near devices which contain magnets or gener-
ate magnetic fields.
• Do not subject the unit to strong physical shock or vibration.
• Keep the unit clean. Dust accumulation can prevent the unit
from functioning properly.
• To protect the unit from damage, hold both sides when you
move it.
8.2. Connections
Important:
• The unit will not function when there is a power failure.
To make calls in emergency situations, you should con-
nect a telephone that can function during a power fail-
ure to the telephone line.
(1) Power cord
• Connect to the power outlet (120V, 60 Hz).
(2) Telephone line cord
• Connect to [LINE] jack and single telephone line jack.
(3) [EXT] jack
• Remove the stopper if attached.
(4) Handset cord
(5) Extension telephone (not included)
Caution:
• When you operate this product, the power outlet should
be near the product and easily accessible.
• Be sure to use the telephone line cord included in this
unit.
• Do not extend the telephone line cord.
• Keep the unit away from walls as far as possible to pre-
vent a recording paper jam.
Note:
Before you can make calls, the dialling mode setting may
need to be changed.
To Next Page
Loading...
