Panasonic KX-FT931LA-B

54
KX-FT931LA-B
10 Test Mode
The codes listed below can be used to perform simple checks for some of the unit’s functions. When complaints are received
from customers, they provide an effective tool for identifying the locations and causes of malfunctions. To do this, you set the
Service mode (Refer to Operation Flow (P.56).) first, then operate the below test items.
Note:
The numbers in the boxes (XXX) indicate the keys to be
input for the various test modes.
Test Mode Type of Mode Code Function
Operation after code
input
FACTORY SET Service Mode “5” “5” “0” Refer to Memory Clear Specification (P.58).
SET
FLASH MEMORY
CHECK
Service Mode “5” “5” “1” Indicates the version and checks the sum of the FLASH MEMORY.
SET
MODEM TEST Service Mode “5” “5” “4” Telephone line circuit is connected automatically, output the following signals on
the circuit line.
1) OFF 2) 9600bps 3) 7200bps 4) 4800bps 5) 2400bps 6) 300bps 7) 2100Hz
8) 1100Hz
SET
SCAN CHECK Service Mode “5” “5” “5” Turns on the LEDs of the CIS and operates the read systems.
Refer to CIS (Contact Image Sensor) Section (P.114).
SET
MOTOR TEST Service Mode “5” “5” “6” Rotates the transmission and reception motor to check the operation of the motor.
12: FAX TX / Reading memory
52: Recording paper is fed
22: Copy
44: Recording Paper reverse
Press [STOP] button to quit.
SET
LED CHECK Service Mode “5” “5” “7” All LEDs above the operation panel board flash on and off, or are illuminated.
SET
LCD CHECK Service Mode “5” “5” “8” Checks the LCD indication.
Illuminates all the dots to check if they are normal.
Refer to Operation Panel Section (P.112).
SET
KEY CHECK Service Mode “5” “6” “1” Checks the button operation.
Indicates the button code on the LCD while the button is pressed. Refer to But-
ton Code Table (P.55).
Refer to Operation Panel Section (P.112).
START (any key)
MEMORY CLEAR
(except History data)
Service Mode “7” “1” “0” Refer to Memory Clear Specification (P.58).
SET
SENSOR CHECK Service Mode “8” “1” “5” If you enter this mode and operate sensor levers with your hands, the LCD dis-
play of the related sensor (or switch) turns ON / OFF. Also, when copying a doc-
ument, the related sensor will turn ON / OFF.
For each sensor’s operation, refer to Sensors and Switches (P.26).
Do Sn Co Jm
: LCD DISPLAY
Do: Document set sensor
:Paper inserted. Turns on when a document is inserted.
Sn: Read position sensor.
:At the read position, turns on when the front cover is opened and the sensor
lever is pressed directory.
Co: Cover open sensor
:Turns on and off when the front cover is opened and closed.
Jm: JAM sensor
:When JAM sensor is on “Jm” functions.
SET
PRINT TEST PAT-
TERN
Service Mode “8” “5” “2” Prints out the test pattern.
Used mainly at the factory to test the print quality.
You can select 1~9. (See Print Test Pattern (P.55))
SET