1. Installation and Quick Start
5
1.4 Recording paper
1 Open the top cover by pressing the top cover release
button (1).
2 Install the recording paper.
3 Insert the leading edge of the paper into the opening
above the thermal head (1).
4 Pull the paper out of the unit.
L Make sure that there is no slack in the paper roll.
5 Close the top cover securely by pushing down on
both sides.
6 For KX-FT982:
Press {FAX/START}, then tear off the excess paper
by pulling it towards you.
For KX-FT988:
Press {FAX/START} to cut the paper.
Correct
Incorrect
Note:
L If the paper is secured with glue or tape, cut
approximately 15 cm from the beginning of the roll
before installing it.
L When the power cord is connected, a message is
printed each time the top cover is opened then
closed. If the recording paper is installed upside
down, the message will not be printed. Install the
paper correctly.
L For accessory information, see page 4.
{FAX/START}
To Next Page
Loading...
