EasyManua.ls Logo

Panasonic KX-FT988FX

Panasonic KX-FT988FX
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9. Help
38
9Help
9.1 Error messages – Reports
If a problem occurs during fax transmission or reception, one of the following messages will be printed on the sending
and journal reports (page 20).
9.2 Error messages – Display
If the unit detects a problem, one or more of the following messages will appear on the display.
Message Code Cause & Solution
COMMUNICATION ERROR 40-42
46-72
FF
L A transmission or reception error occurred. Try again
or check with the other party.
43
44
L A line problem occurred. Connect the telephone line
cord to a different jack and try again.
L An overseas transmission error occurred. Try using
the overseas mode (feature #23 on page 33).
DOCUMENT JAMMED ----- L The document is jammed. Remove the jammed
document (page 44).
ERROR-NOT YOUR UNIT 53
54
59
70
L A transmission or reception error occurred because
of a problem with the other party’s fax machine.
Check with the other party.
JUNK FAX PROH. REJECT ----- L The junk fax prohibitor feature of this unit rejected fax
reception.
MEMORY FULL ----- L The memory is full of received documents due to a
lack of recording paper or a recording paper jam.
Install paper (page 5) or clear the jammed paper
(page 44).
NO DOCUMENT ----- L The document was not fed into the unit properly. Re-
insert it and try again.
OTHER FAX NOT RESPONDING ----- L The other party’s fax machine is busy or has run out
of recording paper. Try again.
L The other party’s fax machine rings too many times.
Send the fax manually (page 20).
L The other party’s machine is not a fax machine.
Check with the other party.
L The number you dialled is not in service.
PRESSED THE STOP KEY ----- L{STOP} was pressed, and fax transmission or
reception was cancelled.
OK ----- L Fax transmission or reception was successful.
Display Cause & Solution
CALL SERVICE L There is something wrong with the unit. Contact our service personnel.
CHECK DOCUMENT L The document was not fed into the unit properly. Re-insert the document. If
misfeeding occurs frequently, clean the document feeder rollers (page 45)
and try again.
L Attempted to send a document longer than 600 mm. Press {STOP} to
remove the document. Divide the document into two or more sheets and try
again.

Table of Contents

Related product manuals