Panasonic KX-HTS824 - Page 76

3.12 LAN Connection
c. Connection using manual settings
Manually set the necessary settings on the wireless extension. Use the settings of the HTS Series
unit for setting the wireless extension's settings.
SSID
Security type
Passphrase
CAUTION
・If settin
g
s related to securit
y
are not
p
erformed, the followin
g
p
roblems ma
y
occur.
-Transmission contents may be intercepted by a third party.
-There may be an illegal system intrusion by a third party.
Note that according to wireless LAN specifications, it is possible to break through the security settings
using special methods. Therefore, use security settings with a full understanding of them.
Note
For details about what values to use for configuring the protocol for specifying an IP address, consult the
network administrator.
3.13 WAN Connection
Description
The following protocols are supported for setting the IP address of the WAN interface.
WAN Type Descri
p
tion
Dynamic IP Address Retrieves an IP address dynamically from your service provider.
Static IP Address Sets a static IP address.
PPPoE Obtains an IP address dynamically from a PPPoE server.
Bridge Configure the WAN using a bridged type.
You can confirm the current connection status of the WAN interface in Web Maintenance Console.
For details about the WAN Status, refer to "Network Confi
g
uration-
[
3-6
]
WAN Status" in the Pro
g
rammin
g
Item Li
s
Conditions
• If the protocol for setting the IP address is changed, you must perform a System Reset and restart the PBX
before the setting can be applied.
• When the built-in router is active, it serves as the default gateway on the LAN-side of the network. The
gateway address distributed by the DHCP feature will be changed to the LAN port’s IP address.
• For details about what values to use for configuring the protocol for specifying an IP address, consult the
network administrator.