6.1 Sending a fax manually
MSetNMCNMDN
MStartN
MRedialN
MQualityN
MFaxN
MSP-PhoneN
1 If the MFaxN light is OFF, turn it ON by pressing
MFaxN repeatedly.
2 Set the original (page 18).
3 If necessary, change the resolution and contrast
according to the type of document.
R To select the contrast, see page 34.
R To select the resolution, see page 34.
4 Dial the fax number.
5 Press MStartN to scan the document into memory.
Wait until “SCAN:PRESS SET” “SEND:PRESS
START” is displayed.
6 To send a single page:
Press MStartN.
To send multiple pages:
1. Place the next page on the scanner glass. A
MSetN
R To send more pages, repeat this step.
2. When all pages are scanned, press MStartN.
Note:
R To stop sending, see page 58.
R While talking to the other party using the
MSP-PhoneN, you can send a fax using the scanner
glass by pressing MStartN, and then M1N (To receive
a fax, press M2N).
R You can change the default operation mode (feature
#463 on page 49) and the timer before returning to
the default operation mode (feature #464 on
page 49).
To select the contrast
Adjust this setting depending on the darkness or
lightness of the document. 5 levels (low to high) are
available.
1. Press MQualityN repeatedly to display “CONTRAST”.
2. Press MCN or MDN to change the contrast.
3. MSetN
Note:
R You can save the previous contrast setting (feature
#462 on page 49).
To select the resolution
1. Press MQualityN repeatedly to display
“RESOLUTION”.
2. Press MCN or MDN to change the resolution.
– “STANDARD”: For normal-sized characters.
– “FINE”: For small-sized characters.
– “SUPER FINE”: For very small-sized characters.
– “PHOTO”: For photographs, shaded drawings,
etc.
3. MSetN
R Using the “FINE”, “SUPER FINE” and “PHOTO”
settings will increase transmission time.
To redial the last number
MRedialN
R If the line is busy, the unit will automatically redial the
number 1 time.
Note:
R To stop sending, see page 58.
Reserving the fax transmission (Dual Access)
You can reserve a fax transmission even when the unit
is just receiving a fax or sending a fax from memory.
– Up to 3 reservations when sending
– Up to 4 reservations when receiving
1. Set the original during fax reception or fax memory
transmission.
2. Enter the fax number using the dial keypad or
phonebook.
3. MStartN
R The unit will scan 1 page. Place the next
document on the scanner glass and press MSetN.
Repeat this until all the documents are scanned,
then press MStartN.
R If the document exceeds the memory capacity, the
reservation for that document will be canceled. You
must send the entire document manually.
Printing a confirmation report
A confirmation report provides you with a printed record
of transmission results. To print the confirmation reports,
make sure that feature #401 is activated (page 50). For
an explanation of the messages, see page 59.
34
6. . Fax (KX-MB1520 only)
6. Fax (KX-MB1520 only)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
