178
KX-MC6020HX
12.3.2.2. Service Function
Code Function Set Value Default Remote Setting
501 Pause time set 001~600 x 100msec 030 OK
503 Dial speed 1:10pps / 2:20 pps 10pps OK
507 V34 transmission start speed (0:Disable/1:33.6/2:31.2/3:28.8/4:26.4/
5:24.0/6:21.6/7:19.2/8:16.8/)
33600bps OK
508 V34 reception start speed (0:Disable/1:33.6/2:31.2/3:28.8/4:26.4/
5:24.0/6:21.6/7:19.2/8:16.8/)
33600bps OK
514 Bell signal detect time 1~9 x 100msec 6 OK
520 CED frequency select 1:2100Hz / 2:1100Hz 2100 OK
521 International mode select 1:ON / 2:OFF ON OK
522 Auto standby select 1:ON / 2:OFF ON OK
523 Receive equalizer select 1:0kms / 2:1.8km / 3:3.6km / 4:7.2km 0 km OK
524 Transmission equalizer select 1:0kms / 2:1.8km / 3:3.6km / 4:7.2km 0 km OK
527 V8 function select 1:OFF / 2:ON ON OK
529 Memory clear for Call Service --------- --------- NG
550 Memory clear --------- --------- NG
551 ROM check --------- --------- NG
552 DTMF signal tone test 1:ON / 2:OFF OFF OK
553 Monitor on FAX communication select 1:OFF / 2:Phase B / 3:ALL OFF OK
554 Modem test --------- --------- NG
555 Scanner test --------- --------- NG
556 Motor test --------- --------- NG
557 LED test --------- --------- NG
558 LCD test --------- --------- NG
561 Key test --------- --------- NG
567 T0 timer 001~255sec 052 OK
570 Break % select 1:61% / 2:67% 61% OK
573 Remote turn-on ring number set 00~99 10 OK
590 FAX auto redial time set 00~99 05 OK
591 FAX auto redial line disconnection time set 001~999sec 065 OK
592 CNG transmit select 1:OFF / 2:ALL / 3:AUTO ALL OK
593 Time between CED and 300bps 1:75ms / 2:500ms / 3:1sec 75ms OK
594 Overseas DIS detection select 1:1st / 2:2nd 1st OK
595 Receive error limit value set 1:5% / 2:10% / 3:15% / 4:20% 10% OK
596 Transmit level set -15~00dBm 10 OK
598 Receiving Sensitivity 20~48 48 OK
599 ECM Frame size 1:256 / 2:64 256byte OK
628 H.V.U check --------- --------- NG
630 Jam Location --------- --------- NG
641 HVU (Bias check) --------- --------- NG
650 Stop Drum Mode 1:Stop / 2:Non stop Stop OK
655 Cause distinction code of call service 3 --------- --------- NG
678 Accumulator Unit Counter Reset --------- --------- NG
717 Transmit speed select 1: 14400bps / 2:12000bps / 3:9600bps
/ 4:7200bps / 5:4800bps / 6:2400bps
14400bps OK
718 Receive speed select 1: 14400bps / 2:12000bps / 3:9600bps
/ 4:7200bps / 5:4800bps / 6:2400bps
14400bps OK
721 Pause tone detect 1:ON / 2:OFF OFF OK
722 Redial tone detect 1:ON / 2:OFF ON OK
763 CNG detect time for friendly reception 1:10s / 2:20s / 3:30s 30s OK
774 T4 timer 00~99 × 100msec 0 OK
815 Sensor check --------- --------- NG
823 Sensor Test 2 --------- --------- NG
831 STR bias OFFSET for Plain Paper 0~30 15 OK
832 STR bias OFFSET for Thin Paper 0~30 15 OK
833 STR bias OFFSET for Transparency 0~30 15 OK
834 STR bias OFFSET for Label 0~30 15 OK
835 STR bias OFFSET for Thick Paper 0~30 15 OK
836 STR bias OFFSET for Card Stock 0~30 15 OK
837 STR bias OFFSET for Envelop 0~30 15 OK
852 Color Printing Test --------- --------- NG
853 Top margin 1~11 x 0.5mm 6 OK
854 Left margin 1~11 x 0.5mm 6 OK
856 Top margin (Duplex) 1~11 x 0.5mm 6 OK
870 Left margin (OPF) 1~11 x 0.5mm 6 OK
871 Left margin (Duplex) 1~11 x 0.5mm 6 OK
To Next Page
Loading...
