Panasonic KX-TCD150FXB

10 THINGS TO DO AFTER REPLACING IC
Cautions:
Since this page is common to each country, it may not apply to some models in your country. The contents below are the
minimum adjustments required for operation.
10.1. Base Unit
IC Necessary Adjustment
BBIC Programs for Voice processing, interface for RF and
EEPROM
1. Clock adjustment: Refer to Check Point (E). (*1)
EEPROM Adjustment parameter data
(country version batch file, default batch file, etc.)
1. Default batch file: Execute the command “Default4KB”.
2. Country version batch file: Execute the command
“150XXvYY”. (*2)
3. Clock adjustment: Refer to Check Point (E). (*1)
Note:
(*1) Refer to Check Point (Base Unit) (P.23)
(*2) XX: country code, YY: revision number
“XX” and “YY” vary depending on the country version. You can find them in the batch file, PQZZ- mentioned in JIGs and PC
(P.27).
10.2. Handset
IC Necessary Adjustment
BBIC Programs for Voice processing, interface for RF and
EEPROM
1. Clock adjustment: Refer to Check Point (H). (*3)
2. 4.0 V setting and battery low detection: Refer to Check Point
(A), (F) and (G). (*3)
EEPROM Adjustment parameter data
(country version batch file, default batch file, etc.)
1. Default batch file: Execute the command “Default”.
2. Default batch file (remaining); Execute the command
“115ADJvYY”. (*4)
3. Melody Initialize batch file; Execute the Command
“InitMelodies143vYY”
4. Country version batch file: Execute the command
“115XXvYY”. (*4)
5. Clock adjustment: Refer to Check Point (H). (*3)
6. 4.0 V setting and battery low detection: Refer to Check Point
(A), (F) and (G). (*3)
Note:
(*3) Refer to Check Point (Handset) (P.31)
(*4) XX: country code, YY: revision number
“XX” and “YY” vary depending on the country version. You can find them in the batch file, PQZZ- mentioned in JIGs and PC
(P.34).
36
KX-TCD150FXB / KX-TCD150FXC / KX-TCD152FXB / KX-TCA115EXB / KX-TCA115EXC