Panasonic KX-TCD150FXB

Note:
*: When you enter the address, please refer to the table below.
Desired Number (hex) Input Keys Desired Number (hex) Input Keys
0 0 A [R] + 0
1 1 B [R] + 1
. . C [R] + 2
. . D [R] + 3
. . E [R] + 4
9 9 F [R] + 5
ex.)
Items (*2) Address Default Data New Data Remarks
C-ID (FSK) sensitivity 0A1D~0A1E 00 6D (3dB up)
00 A4
(6dB up)
00 E7
When hex changes from “006D” to “00A4” or
“00E7”, gain increases by 3dB or 6dB.
C-ID (DTMF) sensitivity 0A 2D 34 (3dB up)
38
(6dB up)
3C
When hex changes from “34” to “38” or “3C”, gain
increases by 3dB or 6dB.
Frequency 00 00~00 01 00 60 - - UsetheseitemsinaREAD-ONLY mode to confirm
the contents. Careless rewriting may cause serious
damage to the computer system.
ID 00 20~00 24 Given value - -
Bell length 0F 12 64 (10sec) (*1) 1E (3sec) 14 (2sec) This is time until bell stops ringing. (Unit: 100ms)
PULSE Dial speed
(10PPS -> 20PPS)
0F 06 28 (40msec) (*1) 14 (20msec) - This is pulse make time. (Unit:1ms)
0F 07 3C (60msec) (*1) 1E (30msec) - This is pulse break time. (Unit:1ms)
0F 0A 4A (740msec) (*1) 2C (440msec) - This is inter-digit time in pulse mode. (Unit:10ms)
(*1)
Bell length 64(hex) = 100(dec) → 100 × 100msec = 10000msec (10sec)
PULSE Dial speed
(10PPS -> 20PPS)
28(hex) = 40(dec) → 40 × 1msec = 40msec
3C(hex) = 60(dec) → 60 × 1msec = 60msec
4A(hex) = 74(dec) → 74 × 10msec = 740msec
(*2)
Items Description
C-ID (FSK) sensitivity FSKGain_shiftgain
C-ID (DTMF) sensitivity Foutgains:HPFilter Foutgains
Frequency Setting value of FREQ_TRIM_REG
ID ID
Bell length Time until it stops bell.
PULSE Dial speed
(10PPS -> 20PPS)
Pulse MakeTime and BreakTime.
bMakeTime:Pulse MakeTime Unit: 1ms
bBreakTime:Pulse Break Time Unit: 1ms
Inter-digit time in Pulse mode.
Unit:10ms
51
KX-TCD150FXB / KX-TCD150FXC / KX-TCD152FXB / KX-TCA115EXB / KX-TCA115EXC