90
Multi-Unit User Operations
Cordless Handset Registration to a Base Unit
The cordless handset supplied with the base unit is already registered. If an optional
cordless handset is purchased, it must be registered as follows.
Charge the optional cordless handset batteries for 7 hours before initial use.
Cordless handset registration must be completed within 1 minute after pressing
. If over 1 minute, press then start over again.
To exit the operation, press at any time.
• If you enter the incorrect Base Unit PIN, an error tone sounds. Repeat from step 1.
• To register a cordless handset to more than one base unit, repeat from step 1 with
the other base unit(s).
• The cordless handset main menu may change depending on the base unit that the
cordless handset is registered to.
1
Press JOYSTICK
(or move).
2
Select “ Setting
Handset”.
3
Select
“Registration”.
4
Select “Register
H/set”.
5
Press and hold button on the Base Unit (for
about 3 seconds) until the tone sounds.
6
Select the desired
base unit.
7
Enter 4-digit Base Unit
PIN.
(Factory Preset 0000)
8
Press JOYSTICK.
When a cordless handset is registered successfully, a confirmation tone sounds and the
“ ” icon is displayed.
&
535HK.book90ページ２００３年９月２２日 月曜日 午前９時１７分
To Next Page
Loading...
