Base Unit Settings
26 Helpline Tel.No. : U.K. 08700 100 076 R.O.I. 01289 8333
Base Unit Settings
You can change the base unit settings using a handset near the base unit.
Before proceeding with any of the base settings listed in this chapter, the
following procedure must initially be carried out:
From the standby mode,
ZZVV
.
ZZSS
/
UU
to select “Setting Base”.
ZZVV
.
“Input Command” is displayed. From this display, follow the instructions
after each heading.
Please note: Where ‘Enter PIN’ is stated in this chapter, it refers to the 4 digit
Base Unit PIN. (The factory setting is 0000).
To exit the menu at any time,
ZZ
PP
.
2
1
3
Ringer Mode
To select all handsets to
ring
ZZAA
.
Enter PIN.
ZZAA
.
ZZVV
.
To select specific
handset(s) to ring
ZZAA
.
Enter PIN.
ZZBB
.
ZZAA
-
FF
to select handset(s).
The selected handsets will be
flashing.
ZZVV
.
To select specific handset(s)
then all handsets to ring
The specific handset(s) will ring for a
selected number of rings. If not answered,
all handsets will ring.
ZZAA
.
Enter PIN.
ZZCC
.
ZZAA
-
FF
to select handset(s)
to ring.
ZZVV
.
ZZAA
-
FF
to select number of
rings.
ZZVV
.
Select Base Unit Ringer
Volume
ZZBB
twice.
ZZKK
(Off) or
AA
-
CC
to
select volume.
ZZVV
.
To Next Page
Loading...
