For Optional Multi-Unit Users
Helpline Tel.No. : U.K. 08700 100 076 R.O.I. 01289 8333 31
(Register Handset):
ZZVV
.
ZZ
and hold
ÏÏ
on the base unit
for 10 seconds. A base registration
tone sounds.
! Handset must be registered
within 1 minute. If over 1 minute
ZZPP
, then restart registration.
ZZSS
/
UU
to select “Base 1-4”.
ZZVV
.
Enter base unit PIN (4 digits -
factory preset is 0000).
ZZVV
.
When handset and base unit
connect a confirmation tone
sounds.
If handset registration is not
successful within 5 minutes, an
error tone sounds.
Register H/Set
(Registration):
ZZVV
.
5
Registration
Cancelling a Handset
Each handset can cancel itself or
another handset.
From the standby mode,
ZZVV
.
ZZSS
/
UU
to select “Setting
Base”
..
ZZVV
.
ZZGG
when “Input Command”
is displayed.
Enter base unit PIN (4 digits).
ZZAA -- FF
to select handset
to cancel. The selected handsets
flash.
ZZYY
.
Cancelling a Base Unit
Follow steps 1 to 5 of
“Registering a Handset to a Base
Unit”, then:
ZZSS
/
UU
to select:
(Cancel a Base Unit)
You can cancel any base unit that your
handset is registered to.
ZZVV
.
Enter handset PIN (4 digits).
ZZSS
/
UU
to select base unit(s) to
cancel.
ZZVV
to set selection.
The selected base unit(s) is (are)
marked with “✓”.
ZZVV
.
ZZSS
/
UU
to select “YES” or “NO”.
ZZVV
to confirm selection.
If selection was YES, “CLEARED” is
displayed briefly.
Cancel Base
Selecting a Base Unit
When “Auto” (Automatic Base Unit
Access) is selected, if you move
outside of the radio range of the
current base unit the handset
automatically searches for other
registered base units.
When a specified base unit is selected,
the handset will access that base unit
only.
Follow steps 1 to 3 of “Registering a
Handset to a Base Unit”, then:
ZZSS
/
UU
to select:
To Next Page
Loading...
